Clarke Extension Cords, INSTRUCTIONS FOR CONNECTION TO THE, POWER SUPPLY AND ELECTRICAL GROUND - 120

Plate

Screw

Outlet must be connected to

Ground Pinthe electrical ground

Figure 7

		Tornillo
		de la
		placa
	El tomacorriente
Terminal de	debe estar
	conectado al
tierra
	borne de puesta
	a tierra
	Figura 7

Borne mâle de la prise

Le réceptacle doit être

Fiche de terreconnecté à la masse

Figure 7

INSTRUCTIONS FOR CONNECTION TO THEPOWER SUPPLY AND ELECTRICAL GROUND - 120 V

CAUTION: This machine will operate only on an AC frequency and on the specified electrical voltage shown on the name- plate. Make sure you have the correct frequency and voltage before connecting the power cord to an out- let.

This machine must be connected to an electrically grounded circuit in order to protect the operator from electric shock. This machine has an approved power cord with three conductors as well as a plug with three terminals. Connect the plug to a three holed receptacle. For maximum protection against electric shock, use a circuit that is protected by a ground fault circuit interrupter.

This machine uses a 120 volt AC 50/60 cycle electrical circuit. Make sure you have the correct frequency and voltage before connecting the power cord to an outlet. The machine has a plug as shown in Figure 7. If a receptacle connected to the electrical ground as shown in Figure 7 is not available, contact an electrical contractor. Do not use an adapter.

WARNING: To prevent possible electric shock, protect the machine from rain. Keep the machine in a dry building.

WARNING: To prevent possible electric shock, always use a 3-wire electrical system connected to the electrical ground. For maximum protection against electrical shock, use a circuit that is protected by a ground fault circuit inter- rupter. Consult your electrical con- tractor.

WARNING: Do not cut, remove, or break the ground pin. If the outlet does not fit the plug, consult your electrical con- tractor.

WARNING: If the cords or plugs are worn or damaged in any way, have them replaced by an authorized service person.

Extension Cords

Use only an approved extension cord with three conductors,

aplug with three terminals and a three-holed connector body. This machine has a power cord with a wire size of 12 AWG. (AWG stands for American Wire Gauge).

CAUTION: If you use an extension cord, use one that has a minimum wire size of 12 AWG. Be sure your extension cord is no longer than 50 ft. Do not join two extension cords.

Page 20 Clarke® BEXT® -100, 100H 150H, 300HV Operator's Manual