1
LOCATOR | 3 | 4 | 5 | 6 |
| ||||
2 | VAC 1 | VAC 2 | PUMP | HEAT |
MODE |
Figure 6
CIRCUIT LOCATOR ( 1 ): When this light is on, it indicates that cord #2 is on a separate line from cord #1. Cord #2 supplies voltage to the heater allowing it to heat to the proper temperature range.
HEAT MODE LIGHT ( 2 ): This light will only illuminate when the heater is heating and will turn off when it reaches operating temperature.
VACUUM SWITCH ( 3 & 4): Each switch turns on one vac motor. turn both switches on for maximum lift. The vac switches illuminate when turned on.
PUMP SWITCH ( 5 ): This switch will illuminate when the pump is on.
HEAT SWITCH ( 6 ) : The heat switch will illuminate when it is activated and will turn the heater on.
5 |
|
| Upholstery |
| |
LOCATOR | 1 | 2 | 3 | 4 | |
| |||||
6 | VAC | PUMP | CARPET | HEAT | |
MODE | |||||
|
|
|
|
Figure 7
VAC ( 1 ) & PUMP ( 2 ) SWITCHES: These switches are powered by cord #1 (4" red band). Switches are on when illuminated.
CARPET / UPHOLSTERY SWITCH ( 3 ): This switch is also powered by cord #1. The carpet setting (down position) is high pressure (approximately 300 psi). The upholstery setting (up position) is low pressure (approximately 75 psi). NOTE: Switch does not illuminate.
HEAT SWITCH ( 4): Turning on this switch (switch illuminates when on) turns the heater on.
GREEN CIRCUIT LOCATOR LIGHT ( 5 ): When this light is illumi- nated, it confirms that the machine is on two separate circuits. See previous page for additional information on the circuit locator.
HEAT LIGHT MODE ( 6 ) : The light will only illuminate when the heater uis heating and will turn off when it reaches operating
temperature.
Page 18 | Clarke® BEXT® |