Having found the serial number, now would be a good time to register your product on the Classé web site or fill out the registration card. Please register your purchase so we can advise you of updates and other items of interest.
It will take only a minute or so. Please register your product on line or complete the card now, before you forget.
The CDT-300 disc transport is set at the factory (internally) for 100V, 120V, 220V, 230V, or 240V AC mains operation, as appropriate for the country in which it is to be sold. (230V only in European Union countries, in compliance with CE regulations.) The voltage setting may not be changed by the user.
Make sure that the label on the rear panel of your DVD transport indicates the correct AC operating voltage for your location. Attempting to operate your DVD transport at an incorrect voltage may damage the unit.
The voltage setting of your DVD transport may not be changed by the user. There are no user-serviceable parts within the unit. Please refer any problems to an authorized Classé service center.
If the AC mains voltage indicated on your DVD transport is incorrect, please contact your local authorized Classé dealer or distributor.
The CDT-300 includes protection circuitry that will prevent the transport from operating at dangerously high or low voltages.
•At startup: the AC mains voltage must be within a range of approximately -15% to +10% of its nominal value at startup, or the transport will not turn on. For example, a 120V unit requires the AC mains to be between approximately 95V–135V in order to turn on.
•Overvoltage during operation: if the AC mains voltage surges by roughly 10% or more during operation, the transport will enter protection mode and shut down. The standby LED (Light-Emitting Diode) will flash to indicate the protection mode has been engaged. An error message will be displayed on the LCD touchscreen.
•Under-voltage during operation: if the AC mains voltage sags by 15% or more, the transport will continue to play (since this does not present a particular danger to the transport), but note that it may not be able to achieve its usual standard of performance under these compromised conditions. The Standby LED will flash to indicate the condition.
