Classe Audio CP-500 owner manual Only one speaker seems to be playing

Important!

Important!

•If your preamplifier was plugged in properly, try the following: put it in standby, switch off the main power switch in the back, and unplug the unit for at least thirty seconds before trying to power it up again. (Sometimes a brownout of short-term loss of power might require a restart.)

Make sure to power down your power amplifier BEFORE doing the restart.

•If none of these solutions work, please consult your Classé dealer for assistance. Never attempt to replace an internal fuse. There are no user-serviceable parts inside your unit.

3.Only one speaker seems to be playing.

•Check the main balance control setting of the CP-500 by pressing the Menu button, followed by the balance button (or simply press Bal on the remote control).

•Does the problem occur with all inputs? If so, check the interconnect cables between the preamp and the power amp. If no fault is found there, check the speaker wires for secure connections.

Be certain that the power amplifier is off before checking any connections between the preamplifier and power amplifier, or between the speakers and the power amplifier.

•If the problem occurs only with a particular input, check the input balance control setting of that particular input:

Menu ➝ system setup ➝ input ➝ input name ➝ balance where input name is the particular input in question.

•If the input balance appears to be correct, check the interconnect cables between the corresponding source component and the CP-500.

4.The IR remote control seems not to function.

•Ensure that there are no obstacles between the IR remote and the IR sensor (located to the right of the Mute button).

•If the batteries are weak, replace them with fresh ones.

33