ClearCube F6151 manual One-Channel Media Converter, Ports, Port Settings

ClearCube F6151 Media Converter and Chassis System

One-Channel Media Converter

Ports

The Converter provides one TX port and one FX port. For the FX port, it provides options of multi-mode fiber using an SC connector. For the TX port, it uses RJ-45 connector, auto-MDIX, and auto senses the speed of 10/100Mbps and full/half duplex.

Port Settings

Port settings are made very simple by means of a DIP (Dual Inline Package) switch at the rear panel of the module.

1 2 3 4 5 6

DIP SWITCH

There are six pins on the DIP switch for port settings. Refer to the table below for more details.

DIP Down (Default Setting) switch

No.

1Enable link-fault-pass- through

2Enable auto negotiation for TX port

3TX port forced to 100Mbps

4TX port forced to full duplex mode

5FX port forced to full duplex mode

6

Up

Disable link-fault-pass- through

Enable forced mode for TX port

TX port forced to 10Mbps TX port forced to half duplex mode

FX port forced to half duplex mode

10 User’s Guide