Cleveland Range 22CGT3 Install the KleanShield Note See Figure, Install the Slide Racks Pan Racks

J.Install the KleanShield™ Note: See Figure 3-9.

Never operate a SteamChef without a properly installed KleanShield™.

1.Place the KleanShield™ into the SteamChef so the drain trough slips into the KleanShield™ drain at the rear of the cooking compartment.

2.Carefully lower the front of the KleanShield™ so the Water Level Sensor Guard is behind the probes and the front legs rest on the bottom of the cooking compartment.

The fan guard helps protect the operator from injury caused by the rotating fan blades. Never operate a SteamChef without the fan guard properly installed.

Operating a SteamChef without the fan guard properly installed can cause injury, equipment damage, and reduce performance.

K. Install the Slide Racks (Pan Racks)

Note: See Figure 3-9.

1.Each slide rack has four loops: two at the top and two at the bottom. Hold the slide rack so the ends of the hanger loops are towards the cooking compartment wall, as shown in Figure 3-9.

2.Slide one rack into the compartment with the hanger loops on the cooking compartment wall side.

3.Hook the loops over the top and bottom pins.

4.Repeat steps 1. through 3. for the other rack.

Fan	Slide Pan
	Rack

	Fan
Door
	Guard

KleanShield™ to	Water	Air Diverter
Drain Fit-up
	Probes

Figure 3-9

Cooking Compartment

12