MAINTENANCE
WARNING:
!Any maintenance or service involving disassembly of components should be made by a qualified service technician. Ensure electrical and water supply (if applicable) to the unit are shut off.
HINGE ADJUSTMENT INSTRUCTIONS
1. | 3. |
FULLY LIFT COVER | WHEN PROPERLY |
TO RELEASE SPRING | ADJUSTED, COVER |
TENSION | SHOULD REST AT 70˚ |
SPRING | 2. | |
USING A | ||
| ||
| 7/16" DEEP | |
| SOCKET | |
| ADJUST LEFT | |
| AND RIGHT | |
| BOLTS | |
| EVENLY |
LUBRICATION PROCEDURE
Lubricate the following parts every three months to insure smooth operation and reduce wear.
Adjusting | TRUNNION | |
HOUSING, | ||
Screw | ||
| WORM SCREW | |
Worm | AND TILT GEAR | |
Screw and | These parts are | |
Tilt | ||
Gear | accessed through the | |
Cross | top cover of the con- | |
Bar | sole. | |
|
Apply grease to gear teeth. Check for exces-
sive play and adjust with adjusting screw located on top of cross bar.
Trunnion Housing |
Grease Nipple |
TRUNNIONS
On the left hand side of the skillet there are two grease nipples on the top back portion of the trunnion housing. On the right hand side of the kettle you must remove the console cover to access the two grease nipples.
15
