Manuals / Cleveland Range / Kitchen Appliance / Oven

Cleveland Range Steam Oven Click Finish to close the screen Configure your serial device

Models: Steam Oven

1 30

Download 30 pages 6.89 Kb

Page 23

Click Finish to close the screen.

Click Finish to close the screen.

Configure your serial device:

1. Right click My Computer, select properties:

Then select the “Hardware tab” and click on the “Device Manager” button.

23

Image 23

Cleveland Range Steam Oven installation manual Click Finish to close the screen Configure your serial device

Contents

FOR USB connection use part number CPC-HACCP-MUUSB Turn off all power to Combis before installation of PC-HACCP NetworkFollow all Safety and Operating Instructions FOR RS232 connection use part number CPC-HACCP-MU232Follow all Safety and Operating Instructions PC-HACCP KIT CONTENTSRead and understand this manual before using this PC-HACCP Kit Photo3 Bracket with Studs 1 - C2114799 1 Electronic Board 1 - C5019104 2 Connector 1 - C5002091RS485 Communication Module p/n C-RS485 5, 6 4,7Photo Photo Photo Photo TO CONNECT THE RS232 CONVERTER TO THE PCPhoto 8 shows the cable connections for the PC Converter The PC Converter wiring is connected to the FIRST Combi in the ChainA RED WIRE B BLACK WIRE GROUND GROUND OR SHIELD WIRE RS232 CABLE CONNECTION FOR CONVERTER TO RS485 ONLYNote the position of the Dongle on the PC in Photo Remove the side panel and set it aside Remove the Control Side CoverTurn the 1/4 turn quick-locks to loosen From the bottom edge of the side panel, push up and pull outRemove the Control Panel Attaching the Base Plate to the Communication Module Photo Attaching the Base Plate to the Communication ModulePhoto PhotoInsert the new bushing, P/N 111751 into the opening attaching the wires to the network boardsInserting the Communication Module Cable into the Oven Remove the sanitary seal plug from the underside of the CombiConnect the Network Cable to the Communication Module Photo Setting the Jumpers on the Communication ModuleBoard and cables are attached Secure cable to the upper right spacer as shown in PhotoPlace Control Board and Module back into the Combi moving partsPhoto Replace the Operation PanelRemount the Operation Panel back into the Combi PhotoTurn the 1/4 turn quick-locks to tighten See the PC-HACCP Instructions to use the PC-HACCP NetworkReplace the Control Side Panel Push up and in from the bottom edge of the side panelDirections for Installing the USB Adapter Ignore this screen if it appears Select install from a list of specific location advancedUncheck “Include this location in the search.” Click Next. Let search The Hardware wizard will appear a second time Follow the directions in each screen Allow search for CD 1. Right click My Computer, select properties Click Finish to close the screen Configure your serial deviceExpand the Ports COM & LPT device Right click on the “USB Serial Port COM??” item Page Page Switches 1 and 4 are ON For USB to RS232 Switches 2, 3, 4 are ON For USB to RS485Place connect jumper #1 Jumper #1 Position Cleveland Range, LLC This Page for Internal Record Only, Not for Printing116 March Rev Page