Manuals / Cleveland Range / Kitchen Appliance / Oven

Cleveland Range Steam Oven For USB to RS232 Switches 2, 3, 4 are ON For USB to RS485

Models: Steam Oven

1 30

Download 30 pages 6.89 Kb

Page 28

For USB to RS232

6.Once the computer recognizes the USB adapter, the dip switches in the adapter have to be set up for RS485 or RS232 data transfer; chose the correct setting to match the configuration you are using.

For USB to RS232

Switches 2, 3, 4 are ON

For USB to RS485

Switches 1 and 4 are ON

28

Image 28

Cleveland Range Steam Oven For USB to RS232 Switches 2, 3, 4 are ON For USB to RS485, Switches 1 and 4 are ON

Contents

Turn off all power to Combis before installation of PC-HACCP Network Follow all Safety and Operating InstructionsFOR RS232 connection use part number CPC-HACCP-MU232 FOR USB connection use part number CPC-HACCP-MUUSBPC-HACCP KIT CONTENTS Read and understand this manual before using this PC-HACCP KitPhoto Follow all Safety and Operating Instructions1 Electronic Board 1 - C5019104 2 Connector 1 - C5002091 RS485 Communication Module p/n C-RS4855, 6 4,7 3 Bracket with Studs 1 - C2114799TO CONNECT THE RS232 CONVERTER TO THE PC Photo Photo Photo PhotoThe PC Converter wiring is connected to the FIRST Combi in the Chain A RED WIRE B BLACK WIRE GROUND GROUND OR SHIELD WIRERS232 CABLE CONNECTION FOR CONVERTER TO RS485 ONLY Photo 8 shows the cable connections for the PC ConverterNote the position of the Dongle on the PC in Photo Remove the Control Side Cover Turn the 1/4 turn quick-locks to loosenFrom the bottom edge of the side panel, push up and pull out Remove the side panel and set it asideRemove the Control Panel Attaching the Base Plate to the Communication Module Attaching the Base Plate to the Communication Module PhotoPhoto Photoattaching the wires to the network boards Inserting the Communication Module Cable into the OvenRemove the sanitary seal plug from the underside of the Combi Insert the new bushing, P/N 111751 into the openingConnect the Network Cable to the Communication Module Setting the Jumpers on the Communication Module PhotoSecure cable to the upper right spacer as shown in Photo Place Control Board and Module back into the Combimoving parts Board and cables are attachedReplace the Operation Panel Remount the Operation Panel back into the CombiPhoto PhotoSee the PC-HACCP Instructions to use the PC-HACCP Network Replace the Control Side PanelPush up and in from the bottom edge of the side panel Turn the 1/4 turn quick-locks to tightenDirections for Installing the USB Adapter Select install from a list of specific location advanced Ignore this screen if it appearsUncheck “Include this location in the search.” Click Next. Let search The Hardware wizard will appear a second time Follow the directions in each screen Allow search for CD Click Finish to close the screen Configure your serial device 1. Right click My Computer, select propertiesExpand the Ports COM & LPT device Right click on the “USB Serial Port COM??” item Page Page For USB to RS232 Switches 2, 3, 4 are ON For USB to RS485 Switches 1 and 4 are ONPlace connect jumper #1 Jumper #1 Position This Page for Internal Record Only, Not for Printing 116 MarchRev Page Cleveland Range, LLC