Manuals / Cleveland Range / Kitchen Appliance / Oven

Cleveland Range Steam Oven RS232 CABLE CONNECTION FOR CONVERTER TO RS485 ONLY, Photo

Models: Steam Oven

1 30

Download 30 pages 6.89 Kb

Page 5

RS232 CABLE CONNECTION FOR CONVERTER TO RS485 ONLY

RS232 CABLE CONNECTION FOR CONVERTER TO RS485 ONLY

Photo 8 shows the cable connections for the PC Converter.

The PC Converter wiring is connected to the FIRST Combi in the Chain.

Photo 8

NOTE:

A:RED WIRE

B:BLACK WIRE

GROUND: GROUND OR SHIELD WIRE

5

Image 5

Cleveland Range Steam Oven installation manual RS232 CABLE CONNECTION FOR CONVERTER TO RS485 ONLY, Photo

Contents

Follow all Safety and Operating Instructions Turn off all power to Combis before installation of PC-HACCP NetworkFOR RS232 connection use part number CPC-HACCP-MU232 FOR USB connection use part number CPC-HACCP-MUUSBRead and understand this manual before using this PC-HACCP Kit PC-HACCP KIT CONTENTSPhoto Follow all Safety and Operating InstructionsRS485 Communication Module p/n C-RS485 1 Electronic Board 1 - C5019104 2 Connector 1 - C50020915, 6 4,7 3 Bracket with Studs 1 - C2114799Photo Photo Photo Photo TO CONNECT THE RS232 CONVERTER TO THE PCA RED WIRE B BLACK WIRE GROUND GROUND OR SHIELD WIRE The PC Converter wiring is connected to the FIRST Combi in the ChainRS232 CABLE CONNECTION FOR CONVERTER TO RS485 ONLY Photo 8 shows the cable connections for the PC ConverterNote the position of the Dongle on the PC in Photo Turn the 1/4 turn quick-locks to loosen Remove the Control Side CoverFrom the bottom edge of the side panel, push up and pull out Remove the side panel and set it asideRemove the Control Panel Attaching the Base Plate to the Communication Module Photo Attaching the Base Plate to the Communication ModulePhoto PhotoInserting the Communication Module Cable into the Oven attaching the wires to the network boardsRemove the sanitary seal plug from the underside of the Combi Insert the new bushing, P/N 111751 into the openingConnect the Network Cable to the Communication Module Photo Setting the Jumpers on the Communication ModulePlace Control Board and Module back into the Combi Secure cable to the upper right spacer as shown in Photomoving parts Board and cables are attachedRemount the Operation Panel back into the Combi Replace the Operation PanelPhoto PhotoReplace the Control Side Panel See the PC-HACCP Instructions to use the PC-HACCP NetworkPush up and in from the bottom edge of the side panel Turn the 1/4 turn quick-locks to tightenDirections for Installing the USB Adapter Ignore this screen if it appears Select install from a list of specific location advancedUncheck “Include this location in the search.” Click Next. Let search The Hardware wizard will appear a second time Follow the directions in each screen Allow search for CD 1. Right click My Computer, select properties Click Finish to close the screen Configure your serial deviceExpand the Ports COM & LPT device Right click on the “USB Serial Port COM??” item Page Page Switches 1 and 4 are ON For USB to RS232 Switches 2, 3, 4 are ON For USB to RS485Place connect jumper #1 Jumper #1 Position 116 March This Page for Internal Record Only, Not for PrintingRev Page Cleveland Range, LLC