Clevo M860TU manual Removing the Hard Disk Drive, HDD Assembly Removal

2.Disassembly

Disassembly

Figure 2

HDD Assembly

Removal

a. Remove the screws.

b. Remove the cover and lo- cate the hdd.



Fan Cable

Make sure you recon- nect the fan cable 9 before screwing down the bay cover.



8. Component Bay Cover

• 7 Screws

Removing the Hard Disk Drive

The hard disk drive is mounted in a removable case and can be taken out to accommodate other 2.5" serial (SATA) hard disk drives with a height of 9.5mm (h). Follow your operating system’s installation instructions, and install all necessary drivers and utilities (as outlined in Chapter 4 of the User’s Manual) when setting up a new hard disk.

Hard Disk Upgrade Process

1.Turn off the computer, and turn it over and remove the battery (page 2 - 5).

2.Locate the component bay cover and remove screws 1 - 7 .

3.Carefully (a fan and cable are attached to the under side of the cover) lift up the bay cover 8 .

4.Carefully disconnect the fan cable 9 , and remove the cover 8 .

5.The hard disk assembly cover will be visible at point 10 on the mainboard.

a.		b.
1	2	3
4
			9
6	7	8	9
5			10

2 - 6 Removing the Hard Disk Drive