Clevo M860TU manual Removing the Inverter Board, Inverter Board Removal

Removing the Inverter Board

1.	Turn off the computer, and remove the battery (page 2 - 5).
2.	Remove any rubber covers, screws 1 - 6 and hinge covers 7 - 8 (Figure 13a), then run your finger around
	the middle of the frame to carefully unsnap the LCD front panel module 9 from the back.

3.Discharge the remaining system power (see “Inverter Power Warning” below).

4.Remove screw 10 (Figure 13b) from the inverter, and carefully lift the inverter board up slightly.

5.Disconnect cables 11 & 12 (Figure 13c) from the inverter, then remove the inverter 13 (Figure 13d) from the top case assembly.

a. 2 3 4 5 b.

10

	c.
1	6
9	11	12
8	7

Disassembly

Figure 13

Inverter Board

Removal

a. Remove the 6 screws and unsnap the LCD front panel module from the back.

b. Remove the screw from the inverter board and lift the board up slightly.

c. Disconnect the cables from the inverter.

d. Remove the inverter.

2.Disassembly

			
Inverter Power Warning	d.	9.	LCD Front Panel
In order to prevent a short circuit when re-		13. Inverter Board
		13
moving the inverter it is necessary to dis-
charge any remaining system power. To do		•	6 Screws

so, press the computer’s power button for a few seconds before disconnecting the in- verter cable.

Removing the Inverter Board 2 - 17