CMA Dishmachines MODEL GL-C manual Maintenance, Lack of pressure in rinse

Maintenance

PROBLEM

LIKELY CAUSE

SOLUTION

Lack of pressure in rinse	Rinse solenoid valve will not	Check coil
spray tube	operate	Check and install rebuild kit
		Replace if necessary
	Rinse solenoid valve strainer	Remove screen and clean
	plugged
Water continues to flow to	Solenoid valve not sealing	Clean seat
detergent tank or spray		Install diaphragm kit
tubes with machine off
		Replace valve
Water temperature low in	Thermostat setting low	Adjust thermostat
detergent tank
	Thermostat defective	Replace
	Defective float switch	Replace
	Heater burnt out	Check and replace
		Ensure water level is above
		element
	Incoming water temp. low	Hot water supply
		min.140°F/60°C
Water on floor around	Pump seal leaking	Replace
machine
	Rinse drain in wash area plugged	Clear obstruction, clean
		machine
	Wash return screen in detergent	Clean
	tank plugged
	Drain screen under detergent	Clean
	tank plugged
	Main drain plugged	Clean
	Detergent tank covers are not	Position all top covers to
	positioned properly causing	completely cover top of tank
	condensation
	Fill chute has lime build-up	De-scale detergent tank
Chemical containers filling	Dirty rinse tubes	Clean
with water
	Worn flow washer in solenoid	Replace
	valve
Chemicals not feeding	No product in containers	Refill containers
	Product gelling or crystallizing in	Flush all lines with hot water
	chemical line	and use fresh supply of
		chemical
	Chemical supply strainer plugged	Clean with hot water
	Speed adjustment set too low	Increase by turning clockwise
		while machine is running/filling
	No power to pump	Check LED signal
	Pump motor defective	Replace pump motor
MODEL GL-C Installation & Operation Manual Rev. 1.00 –2/23/06		Page 9