Cobra Electronics AN - 8630 - 25 manual Using the 2-WAY Recording Feature, To Use The Intercom

3 1

To Use The Intercom

11. If you are at the handset and wish to

BUTTONINTCM	speak with someone at the base, press
	and release INTCM which will sound
	three beeps and light the red indicator
	next to the INTERCOM/PAGE button on
	the base. The person may then respond
	just by speaking into the base.
2	2. If you are at the base and wish to page
	someone at the handset, press and
INTERCOM/PAGE	release INTERCOM/PAGE, which will
BUTTON	sound a series of three beeps and light
	the INTCM button on the handset. The
	person may then respond by pressing
	INTERCOM and speaking into the
	handset. The LED display will read	In

13. To end the conversation, simply press

INTCM	the INTCM button on the handset again.
BUTTON	You cannot disconnect the INTCM from
	the base.

34. If you receive a call during an intercom

Cobra®

To Use The Intercom/Pager

As A Handset Locator

21. To locate a misplaced handset around the home, press and release the

INTERCOM/PAGE	INTERCOM/PAGE button on the base.
BUTTON	2. The handset will sound a series of
	three beeps for 30 seconds, giving you
	time to locate it. Once found, press and
	release the INTCM button on the handset

1twice to eliminate the signal.

INTCM 3. If you have not located the handset in

BUTTON

30 seconds, repeat steps above.

To Use The Intercom As

A Monitor

Monitor the room in which the base is located from another location using the Intercom feature.

11. Press INTCM button on handset. This

INTCOMengages the Intercom microphone in

BUTTON	the base, allowing you to listen to the
		1
	base location area.
	2. Listen through the handset for as long
	as you like.

TALK

conversation, you will hear a low volume

4

Cobra®

Cobra®

BUTTON ringing in the handset. Press TALK, which will disconnect the intercom and connect you with the incoming call.

4	5. If you wish to page someone at the
HOLD
BUTTON	base while you are talking on the phone,

1press HOLD then INTCM. TALK button

INTCM	will flash to remind you you have a call on
BUTTON	hold. Press TALK to disconnect Intercom

3and resume your phone call.

TALK

BUTTON 6. If someone tries to reach you on the Intercom while you are talking on the handset, you will hear three rings. Press

4HOLD, then INTCM on the handset. (The

HOLD	base will beep and Intercom will activate.
BUTTON	LED will flash when there is a call on

1hold). Your caller will then be put on hold INTCM while you answer the INTCM. The TALK

BUTTON button will flash to remind you that you

3have a call on hold. Press TALK again to TALK disconnect the INTCM and reconnect

BUTTON with your telephone call.

2 REPEAT SKIP

1	3.	Disconnect by pressing INTCM again.
INTCOM	4.	If you receive an incoming call while
BUTTON		you are using the monitor, you will
		hear a ringing in the handset.

35. Press TALK to connect the call. The

TALK	Intercom is automatically
BUTTON	disconnected.

USING THE 2-WAY RECORDING FEATURE

If you want to record your conversation, you must ask the person to whom you are speaking for their permission. Press and immediately release the MEMO/2- WAY record button. The LED display will read 2–. To stop recording, press STOP button or hang up.

AN8630-25 NEED HELP? 1-773-889-3087