Cobra Electronics CXR925C Channels, Listening for a Response, Time-out Timer, Call Button

Operation	Using Your Radio
Channels		•
	With the radio on, select any of the
Channel Button
	22 channels by pressing the Channel Up
	or Channel Down button.
	Both radios must be tuned to the
	same channel to communicate.

Channels 1 through 7 are shared by FRS and GMRS.

Channel Number Channels 8 through 14 are FRS only. Channels 15 through 22 are GMRS only.

See page 26 for FRS/GMRS frequency
allocations and compatibility charts.
Listening for a Response	•

Introduction Operation Customer Assistance Warranty

Time-out Timer		•
Talk Button	The Time-out Timer feature limits transmit time to
	three (3) continuous minutes to extend battery life
	and prevent accidental operation. After three (3)
	continuous minutes of transmission, the radio will
	stop transmitting and will require a rest period of 30
	seconds. During this time the display will flash on
	and off, and an error tone will sound if the Push-to-
	Talk button is pressed.
Selectable High•Medium•Low
Power Output		•
Hi-Low Button	When in close proximity to another party or during
	favorable conditions, you can switch from High to
	Medium to Low Power to extend battery life.

Listening	Release the Talk button to receive incoming
	transmissions. Your microTALK® radio is always in
	Standby mode while the Talk or Call buttons are
	not pressed.

Call Button		•
	To alert another person that you are calling:
Call Button

–Press and release the Call button.

	The other person will hear a two (2) second
	call tone. This tone is used only to establish voice
	communications.
	See page 24 on how to select from
	10 available call tone settings.
To Illuminate Display		•
	Press and release the Light/Max Range
Light/Max Range
	button to illuminate the display for
	10 seconds.

Hi Power Icon

Medium Power Icon

Low Power Icon

This feature applies to GMRS Channels 1 through 7 and 15 through 22 only. Channels 8 through 14 operate exclusively on low power.

To switch from high to medium to low power:

–Press and release the Hi•Low button.

When in High Power and using Channels 1 through 7 and 15 through 22, the Hi icon will be visible in the LCD display.

When in Medium Power and using Channels 1 through 7 and 15 through 22, the Med icon will be visible in the LCD.

When in Low Power or while using channels 8 through 14, the Low icon will be visible in the display.

When using an external speaker/ microphone accessory on channels 1-7 or 15-22, your microTALK® radio will only operate on medium or low power.

4English

Nothing Comes Close to a Cobra® 5