Cobra Electronics MR HH330 FLT EU owner manual Setup Mode Programming, Marine VHF Mode Programming

Operating Your Radio

H-M-L Power Button

Call/Enter/Setup Button

Getting Started

High/Medium/Low (H-M-L) Power Button

Your radio can transmit selectively at 1, 3 or 6 watts of power (5 watts in Australia). Cobra suggests you maintain the low power setting for short-range communications. You will conserve battery life and avoid overpowering nearby stations with a low power setting signal. Use the high power setting for long-range communications

or when you do not receive a response to a signal sent at 1 watt.

To Toggle Between H-M-L Power Modes:

Press the H-M-L Power button. The LCD will show which mode is in effect. Some channels are restricted for a maximum use of 1 watt. Your radio will automatically set the power to Low Power mode when you select those channels.

NOTE

Some channels, frequency bands and countries of use might not be able to operate in High Power mode.

Call /Enter/Setup Button

Setup Mode Programming

Operating Your Radio

Setup Mode Programming

•

The following series of procedures is designed to allow you to set the programmable features of your radio. Correctly following these steps results in a minimal amount of radio setup programming time.

NOTE

When in the Setup mode, if you stop programming for longer than 15 seconds, your entry will be saved and the radio will go back to the Marine Standby mode. When you return to Setup mode and continue programming you will see the last “value” displayed. While in the Setup mode, you will not receive any signal reception.

Marine (VHF) Mode Programming

Programming these features will allow you to customize certain features of this radio to enhance your “On-Water” audio needs.

Start from Marine Standby mode to begin Marine (VHF) Setup programming. Press and hold the Call/Enter/Setup button for two (2) seconds to enter the programming mode.

The mode programming follows this sequence:

The Call/Enter/Setup button has multiple functions. It is generally used in the following ways:

n Press and release to transmit your unique Call Tone signal to another radio.

n Press and hold to enter any Setup menu.

nFunctions as an Enter button when making a selection in any Setup menu.

16 English

nSquelch Level Set n Channel Map

n Tone Alert On/Off n Call Tone Select

n Roger Beep On/Off n Key Tone On/Off

n ATIS On/Off (Displayed only when ATIS enabled)

Nothing Comes Close to a Cobra® 17