Cobra Electronics MR HH330 FLT EU owner manual Memory Location Mode, Tri-Watch channel

Operating Your Radio

Channel Up/Down Button

TRI-WATCH Button

Tri-Watch Scan Mode

Advanced Operation

2.Press Channel Up/Down button to select the desired

Tri-Watch channel.

3.Press and release TRI-WATCHbutton or Call/Enter/Setup button to confirm entry.

4.Repeat steps 2 and 3 to program the remaining additional Tri-Watchmemory channel.

5.After programming both Tri-Watchmemory channels the radio will immediately engage

Tri-Watch mode.

Using Tri-Watch

Tri-Watch Scan Mode:

1.From Marine Standby mode, press the TRI-WATCHbutton. The TRI icon will appear on the LCD display and the radio will scan through the three (3) Tri-Watchmemory channels.

2.A signal on any one (1) of the three (3) channels will stop the scan for 10 seconds to allow you to listen to the traffic on that location.

NOTE

After the Tri-Watchscan stops to monitor a channel, as long as you do not press any buttons within 10 seconds, your radio will automatically resume scanning the Tri-Watchchannels.

3.Press the Channel Up/Down button to resume scanning the Tri-Watchchannels or to change the scan direction.

4.To EXIT the Tri-Watchscan, press the TRI-WATCHbutton again. The TRI icon will disappear from the LCD and the radio will return to Marine Standby mode.

Operating Your Radio

MEM/ESC Button

Memory Location Number

Channel Up/Down Buttons

Channel Number

Advanced Operation

Memory Location Mode

Your radio has unlimited memory locations for storing your most frequently used channels. These memory locations can be selected individually or can be scanned. (See page 28 under Memory Location Scan.)

To enter Memory mode, press MEM/ESC button. The display will show the MEM icon and the Memory Channel bank will be activated and displayed.

To Program Memory Locations:

1.Press and hold the MEM/ESC button for two (2) seconds. The memory location number will start flashing and the MEM icon will be turned On.

2.Use the Channel Up/Down button to advance to the memory location (00-99) you want to program.

3.Press the MEM/ESC button to select the memory location. The memory channel number will stop flashing and the channel number will start flashing.

4.Use the Channel Up/Down button to change to the channel you want to store into the selected memory location.

5.Press the MEM/ESC button to program that channel. The memory location number will flash again.

Repeat steps 2 through 5 to program as many additional memories as you want.

6.Press and hold the MEM/ESC button for two (2) seconds. This will return the radio to Memory mode.

7.Press and release the MEM/ESC button again to return to Marine Standby mode.

24 English Nothing Comes Close to a Cobra® 25