Operating Your Radio

MEM/ESC Button

SCAN Button

Product Features

To Enter Memory Location Scan:

1.From Marine Standby mode, press the MEM/ESC button.

2.Press the SCAN button. The radio will immediately begin to scan all pre-assigned memory channels. The SCAN and MEM icons will show on the LCD.

3.A signal on any channel will stop the scan for 10 seconds to allow you to listen to the traffic on that location.

4.Press the Channel Up/Down button to resume scanning the Memory Location Scan channels or to change the scan direction.

5.To EXIT Memory Location Scan mode, press the SCAN button again. The SCAN and MEM icons will disappear from the LCD and the radio will return to Marine Standby mode.

Maintenance and

Troubleshooting

Operating Your Radio

Maintenance

Very little maintenance is required to keep your CobraMarine VHF radio in good operating condition:

Keep the radio and charger clean by wiping with a soft cloth and mild detergent. Do not use solvents or harsh or abrasive cleaners, which could damage the case or scratch the LCD screen.

If the radio is exposed to salt water, wipe with a soft, moist cloth at least once a day to prevent buildup of salt deposits, which could interfere with button operation.

If the radio will be stored for a long period, such as over the winter, remove the batteries from the battery tray and store them in a separate package. This is especially important if you are using alkaline batteries.

Troubleshooting

 

 

 

 

 

 

Problem

Possible Cause(s)

Solution(s)

 

 

 

No display on LCD when

Batteries are exhausted

Recharge or

radio is turned On

 

replace batteries

 

Batteries not installed

Remove batteries and

 

properly

reinstall according to

 

 

polarity markings

 

 

 

NiMH batteries run

Batteries are at the

Replace with new

down quickly

end of their life

batteries

 

 

 

Will transmit at

Batteries are low

Recharge or

one (1) or three (3) watts,

 

replace batteries

but not at five (5) watts

Selected channel is imited

Switch to

 

 

to one (1) watt

another channel

 

 

 

Will not transmit

Selected channel is

Switch to

 

limited to receive only

another channel

 

 

 

No sound from speaker

Volume level is too low or

Re-adjust volume

 

squelch level is too deep

and squelch

 

 

 

No response to

Button lock is On

Press Backlight/

button press

 

Key Lock button

 

 

 

No answer to calls

Out of range of

Switch to three (3) or five

 

other station

(5) watts or move closer

 

Signal is blocked

Move until you have a “line-

 

by terrain

of-sight” to the other station

 

 

 

58 English

Nothing Comes Close to a Cobra® 59

Page 33
Image 33
Cobra Electronics MRHH325VP owner manual Maintenance Troubleshooting