Operating Your Radio

WX Auto Search (SCAN)

Standby/Receive

and Transmit

WX Auto Search (SCAN) Mode Function:

The purpose of the WX Auto Search (SCAN) function is to enable the receiver to automatically scan for an active WX channel under the following conditions:

1.WX Auto Search (SCAN) function is On.

2.WX Alert is On.

3.The radio is tuned to a Marine VHF channel and has entered Power Save mode (meaning there is no signal activity or user input for 10 seconds).

4.The radio software has detected that the current WX channel signal level has dropped below a preset minimum level or is gone completely.

Once these conditions have been met, the software will then scan the WX channels looking for an active WX channel. When an active WX channel is found, it will stop the scan and use the new WX channel to look for the standard 1050Hz alert tone.

Operating Your Radio

Advanced Operation

 

Advanced Operation

 

Channel 16/9 Mode

 

 

 

Channel 16/9 mode gives you quick access to calling on

 

 

Channel 16 and Channel 9 from any operational mode.

 

Channel 16/9 Button

To Switch to Channel 16 or Channel 9:

 

 

1. Press the Channel 16/9 button to change to

 

 

Channel 16.

 

2.Press the Channel 16/9 button again to change to

Channel 9.

3. Press the Channel 16/9 button a third time and return to the last used Standby channel.

Channel 16 or Channel 9

 

 

 

 

50 English

Nothing Comes Close to a Cobra® 51

Page 29
Image 29
Cobra Electronics MRHH325VP owner manual Advanced Operation, Channel 16/9 Mode