STANDBY
SOURCE SELECT
USB
1 | 2 | 3 |
4 | 5 | 6 |
7 | 8 | 9 |
| 0/10 | 10+ |
ENTER
SETUP
GOTO
PROGRAM
Playback
Switch on the unit. /Put the unit in standby mode.
Note: Being in the standby mode uses a minimal amount of electricity, but ensures that the components of the unit operate at maximum efficiency from the moment you start.
Press repeatedly to select a signal source among DVD, TUNER, LINE 1 and LINE2.
Press this button, use the direction key [ ]/[ ] to select a signal source, DVD, USB or CARD, then press [ENTER] to access the corresponding mode.
The digit keys can be used to input the corresponding numbers or make selection of a track or a chapter of a disc, etc.
Press to enter an item in the menu or to confirm your operation etc.
The direction keys can be used to move the highlight or adjust the value of an item in the menu .
Press to enter/exit the setup menu.
During playback, press to enter the GOTO menu. In the menu, use the direction key [ 
]/[ 
] to select a setting item and press [ENTER] to enter the editing state, then with the digit keys input a specific track, disc time, track time, chapter, title, chapter time or title time to go to directly. Press it again to exit the GOTO menu.
Press this button to enter/exit the program menu with which you can playback the contents of a disc in your desired order.
In the program menu, use the direction keys, digits keys and [ENTER] to make a program list, then move the highlight to START and press [ENTER] to start program playback.
During program playback, press [PROG] to enter the program menu and the STOP is highlighted, press [ENTER] to cancel program playback.
