Comprobación de Fugas
■Asegúrese que la VALVULA DEL COMBUSTIBLE está completamente “CERRADA” (“OFF”).
■COMPRUEBE SI HAY FUGAS de una o más formas. Vea si hay o una neblina de combustible o lo que parece ser humedad de combustible sobre las superficies. Escuche por un siseo de gas escapándose. Huela por olor de combustible. No use nunca una llama. No la use si tiene una fuga. (Fig. 9)
COMPRUEBE | COMPRUEBE |
POR FUGAS | POR FUGAS |
| COMPRUEBE |
| POR FUGAS |
Fig. 9
Como instalar el tanque
■Inserte el generador por el orificio grande al frente de la estufa y dentro de la cámara de mezcla arriba del quemador. Coloque las presillas del tanque dentro de las ranuras al frente de la estufa. (Fig. 10)
Fig. 10 |
■Gire los DEFLECTORES DE VIENTO hacia afuera e inserte las PRESILLAS METÁLICAS dentro de las ranuras en los extremos de la estufa. (Fig. 11)
Fig. 11 |
Como Encender el Quemador Principal
ADVERTENCIA
•Realice las pruebas de fuga al aire.
•Apague todas las llamas abiertas.
•NO compruebe NUNCA si hay fuga cuando esté fumando.
•No use la estufa al aire libre hasta que la conexión ha sido comprobada por fuga y no halla fuga.
ADVERTENCIA
•PELIGRO DE QUEMADURA
•No deje nunca la estufa desaten- dida cuando esté caliente o en uso.•Manténgala fuera del alcance de los niños.NO LLENE O ENCIENDA NUNCA LA ESTUFA DENTRO DE LA CASA, CARAVANA O TIENDA DE CAMPAÑA.
■Cierre la VÁLVULA AUXILIAR (O VÁLVULAS). Mueva LA PALANCA DE ENCENDIDO hacia ARRIBA (UP). (Fig. 12 & 13)
|
|
|
|
|
| Fig. 12 |
| Fig. 13 | |
|
|
|
|
|
Troubleshooting
Symptom | Problem | Solution |
|
|
|
Burner will not | Fuel tank empty. | Refill fuel tank with clean and |
light or flame self- |
| fresh Coleman® Liquid Fuel or |
extinguished. |
| unleaded fuel. |
|
|
|
Burner will not | Little or no pressure in fuel | Check that fuel cap is tight and |
light or flame is | tank. | pump 30 strokes. |
low or flame self- |
|
|
extinguished. |
|
|
|
|
|
Yellow flame. | Excess fuel in burner. | A yellow flame is normal until the |
|
| generator warms up. If yellow |
|
| flame persists, turn off stove, |
|
| allow flame to |
|
| the stove to cool. If necessary, |
|
| invert stove to remove excess |
|
| liquid fuel from the burner. Follow |
|
| lighting instructions. |
|
|
|
Low heat. | Generator tip plugged. | Turn LIGHTING LEVER up and |
|
| down several times to clean |
|
| generator tip. Be sure to use only |
|
| fresh and clean fuel. |
|
|
|
Low heat. | Faulty generator. | Replace with a new generator. |
|
| This is a normal periodic |
|
| maintenance procedure. The |
|
| generator life is dependent on |
|
| the type of fuel used. Generator |
|
| life is extended by using clean |
|
| Coleman® Liquid Fuel. |
|
|
|
Persistent small | Faulty generator. | Replace with a new generator. |
yellow flame. |
|
|
|
|
|
Persistent high | Failure in the fuel delivery | May need to replace pump |
yellow flame. | system. | assembly. Please contact |
|
| Consumer Service (see page 9). |
|
|
|
Yellow smokey | Spider webs, insects, or | Remove burner to inspect and |
flame. | other obstruction in the | clean the burner and air tube. |
| burner and air tube. |
|
|
|
|
Pump does not | Pump seals are dry or | Squirt a few drops of oil in the OIL |
pressurize the | worn. | HOLE in the pump cap. This will |
liquid fuel |
| keep the pump functioning properly |
canister. |
| |
| (Fig. 26). If this does not correct the | |
|
| |
|
| problem, replace the pump seals or |
|
| purchase a new pump assembly. |
|
|
|
Intermittent yellow | Flame requires adjustment. | Adjust the flame to a slightly |
flame after |
| higher level with the FUEL VALVE. |
extended use on |
|
|
low heat setting. |
|
|
|
|
|