Coleman 7700 LP Gas Series, 7700 Series manual 31-C, 32-A, 32-B

31-C	DY (x2)
	UO (x2)
TN (x2)
Left Mount Bracket

31-C. Attach the Left Support Bracket to the metal side panel using two Screws (TN), two Flat Washers (DY) and two Hex Nuts (UO).

NOTE

IF YOU ARE INSTALLING THE SHORT SPIT ROD FOR USE ON THE RIGHT BURNER, PROCEED WITH

STEP 32.

IF YOU ARE INSTALLING THE LONG SPIT ROD FOR USE ON THE RIGHT BURNER AND LEFT BURNER, SKIP

TO STEP 33.

Ö Install the Short Spit Rod into the Firebox.

Step
32
32-A	NOTE:
Slip Collar
	Machined
	Groove
Fork	Toward
	Handle
	Short Spit Rod
Handle
Set Collar
	Fork

32-A. Loosely assemble the Rotisserie parts as shown in Figure 32-A. Do not tighten the thumbscrews until properly positioned in the grill.

32-B
	Set Collar
Small Gap here
Center
Firebox
Wall	Slip Collar

32-B. Insert the Spit Rod into the Motor. Make sure the machined groove is toward the handle.

ÖPlace Slip Collar on Firebox Wall. Make sure the pointed tip of the Spit Rod stays in the Motor.

ÖPush Set Collar against the Slip Collar, provide a small gap to allow the Spit Rod to freely turn.

ÖTighten the thumbscrews on the Set Collar

and the Forks to hold in place. 31