Natural Gas Conversion Instructions
16.Start by placing the new manifold into the grill body with the control knob stems going outward through control panel front (Fig. 15).
17.Reattach the bezels to the manifold with the two screws. Make sure that "off" is facing up on the bezel. (Fig. 12 & 13).
18.Reattach the flexline on the right of the grill to the new manifold using the adjustable wrench (See Fig. 9 on previous page).
19.Reattach the flexline on the left of the grill to the back infrared valve using an adjustable wrench (Fig. 16).
20.Reattach the control knobs onto the manifold stems, making sure the arrow is facing upwards (See Fig. 11 on previous page).
21.Reinstall burners into the grill body. Line up the burners with the valves on the manifold, making sure they are level (Fig. 17 & 18).
22.Reattach the electrode and their heat shields to the burners (Fig. 2, 3, and 4).
23.Reattach the rear heat shield before attaching the front heat shield to be sure the burners remain over the valves (Fig. 19).
24.Reinstall the front heat shield (Fig. 5, 6, and 7).
25.Reinstall the heat tents (Fig. 1).
26.Reinstall the cooking grates.
Control Knob
Stems
Fig 15
Manifold
Fig 16
Valves
Burners
Fig 17
Burners fully
over valves
Fig 18
Rear Heat Shield
Fig 19
6
