Operation
DANGER
•CARBON MONOXIDE HAZARD
•For outdoor use only.
•Never use inside house, camper, tent, vehicle or other unventilated or enclosed areas. This unit consumes air (oxygen). Do not use in unventilated or enclosed areas to avoid endangering your life.
DANGER
•EXPLOSION - FIRE HAZARD
•Propane is heavier than air and can accumulate in low places. If you smell gas, leave the area immediately.
•Always attach or detach propane source outdoors; never while unit is lighted, near flame, pilot lights, other ignition sources or while unit is hot to touch.
•This unit is very hot during use and can ignite flammables too close to the burners.
•Minimum distance shall be at least 10 ft (3 m) from any structure or combustible material.
•Do not use gas fryer on or under any apartment, or condominium balcony or deck.
•Keep gasoline and other flammable liquids and vapors well away from unit.
■Do not attempt to operate until you have read and understood all General Safety Information in this manual and all assembly is complete and leak checks have been performed.
Fryer Burner
Lighting
WARNING
•BURN HAZARD
•This appliance will be hot during and after use. Use insulated oven mitts or gloves for protection from hot surfaces or splatter from cooking liquids.
•Never leave fryer unattended when hot or in use.
•Keep out of reach of children.
INSTASTART™ Electronic Ignition Fryer:
1.Open the lid.
2.Make sure all valves are OFF.
3.Turn on the cylinder valve.
4.Push in and turn on the Fryer Control Knob counterclockwise to HIGH. (Fig. 17).
5.Continue to depress and hold the Fryer Control Knob.
6.Repeatedly press the igniter switch until the flame ignites.
7.After burner ignition, continue to hold Fryer Control Knob in for
8.If ignition does not occur in 5 seconds, turn the Fryer Control Knob off, wait 5 minutes, and repeat the lighting procedure.
9.If the burner does not light after trying again, turn off Fryer Control Knob and try match lighting the burner.
HINT: If the igniter fails to light the fryer burner, adjust electrode tip with needle- nose pliers. A spark must jump near a gas opening in the burner when igniter is activated. Use care not to damage the ceramic insulator on electrode.
Depress |
and Hold |
Push |
Repeatedly |
Fig. 17 |
10.Observe the flame from below the fryer, looking between the fryer housing and the grease tray (Fig. 18).
11.Flame should be blue with a hint of yellow on tips.
Fig. 18