GENERATOR CONTROL PANEL
FEATURES
ATwo line by twenty character LCD provides the primary visual interface for metering, alarms, pre- alarms and protective functions. In the normal mode, labels appear above and below the display. In the alternate display mode, labels and the displayed value appear on the display.
BRed LED turns ON when the device is not in the AUTO mode.
CRed LED turns ON continuously for all alarm conditions and flashes for
DGreen LED turns ON when the generator is supplying more than two percent of generator full load rated current.
EPushbutton used to silence an optional audible alarm.
FPushbutton used to exercise all segments of the LCD and to illuminate all LED’s.
GPushbutton used to place the device in AUTO mode.
WARNING
•With the Mode switch in the Auto position, the unit starts and stops without notice.
•Keep clear of all moving parts at all times.
HGreen LED turns ON when the device is in the AUTO mode.
WARNING
•Place the circuit breaker in the OFF position when servicing the generator to minimize electrocution hazards.
IPushbutton used to place the unit in the OFF mode.
JRed LED turns ON when the device is in the OFF mode.
KPushbutton used to place the device in the RUN mode.
LGreen LED turns ON when the device is in the RUN mode.
MPushbutton used to scroll through the displays available in the normal display mode.
NPushbutton used to scroll through the display modes.
OPushbutton used to scroll through previous menu levels.
PPushbutton used to enter menu sublevels and select set points.
QPushbutton used to scroll backward through the menus and to decrement set points.
RPushbutton used to scroll forward through the menus and to increment set points.
Generator Control Panel
14
