Compaq Memory Channel Hub manual Attaching the Slide Assemblies to the Cabinet Rails

Installation

2.4.2 Attaching the Slide Assemblies to the Cabinet Rails

The following sections contain the procedures for attaching the right and left slide assembles to the cabinet rails.

2.4.2.1 Attaching the Right Slide Assembly to the Cabinet Rails

To attach the right slide assembly to the cabinet rails, refer to Figure 2-2 and proceed as follows:

1.Determine the proper mounting holes for the right slide brackets. The proper mounting holes are the 1st, 2nd, and 3rd holes of the installation area (see Figure 2-1).

2.Locate the right slide assembly.

3.Place the right front slide bracket on the inside of the right front rail and align the three slide bracket holes and with the 1st, 2nd, and 3rd holes of the installation area on the right front rail.

4.Install two 10-32 truss-head screws ôin the 1st and 3rd holes of the installation area to secure the right front slide bracket to the right front rail, but do not tighten.

5.Install a 10-32 standoff öin the 2nd hole of the installation area on the right front rail. Tighten this standoff.

6.Place the right rear slide bracket on the inside of the right rear rail and align the three slide bracket holes and with the 1st, 2nd, and 3rd holes of the installation area on the right rear rail.

7.Install three 10-32 truss-head screws õin the 1st, 2nd, and 3rd, holes of the installation area to secure the right rear slide bracket to the right rear rail, but do not tighten.

8.Tighten the two 8-32 screws and nuts that secure the right rear slide bracket to the right slide assembly.

9.Securely tighten all five 10-32 truss-head screws that secure the right slide assembly to the right front and rear cabinet rails.

10.Install a 10-32 standoff úin 14th hole of the installation area on the right front rail and secure it in place with a 10-32 nut.

2–6DIGITAL 2T-CCMHA-CB Central Office Memory Channel Hub Installation/Service Guide