Compaq Memory Channel Hub manual Mounting the Chassis and Tray Assembly on the Slides

Installation

2.4.5 Mounting the Chassis and Tray Assembly on the Slides

To mount the chassis and tray assembly on the slides, refer to Figure 2-5 and proceed as follows:

_______________________ WARNING __________________________

The 2T-CCMHA-CB central office Memory Channel hub can weigh up to

13.6kg (30 lb.). Use suffi ient personnel or the proper lifting equipment when lifting or moving the system.

___________________________________________________________

_______________________ ACHTUNG__________________________

Der 2T-CCMHA-CB Central Office Memory Channel Hub kann bis zu 13,6 kg (30 lb) wiegen. Beim Hochheben oder Transport des Systems sollten deshalb genügend Hilfskräfte vorhanden sein oder die richtigen Hebewerkzeuge benutzt werden.

___________________________________________________________

Stabilize the cabinet before installing the chassis and tray assembly into the cabinet.

1.Pull both slide assemblies cout fully to their locked positions.

2.Lift the chassis and tray assembly and position it so that the inner slide races öfit into the front end of the slides.

3.Push the chassis and tray assembly into the slides until it stops. Push in on the two locking levers õand then push the system into the cabinet.

4.Secure the chassis to the front cabinet rails using four 10-32 truss-head screws ú. The screws go through the front bezel and into the four standoffs previously installed in the 2nd and 14th holes of the left and right front cabinet rails.

2–12DIGITAL 2T-CCMHA-CB Central Office Memory Channel Hub Installation/Service Guide