Solving Lamp Problems
Lamp shuts off | 1. If all five projector panel buttons |
| flash amber, the projector has |
| overheated and will automatically |
| shut down. Wait |
| until the buttons stop flashing |
| and the Standby button turns |
| amber before restarting the |
| projector again. |
| 2. A minor power surge may cause |
| the lamp to shut off. Turn the |
| projector off. Wait a few minutes, |
| then turn it back on. |
|
|
Lamp burns out or makes a | When the lamp reaches its end of life, |
popping sound | it will burn out and may make a loud |
| popping sound. If this happens, the |
| projector will not turn back on until |
| the lamp module has been replaced. |
| For information on purchasing a |
| replacement lamp module, call your |
| Compaq authorized dealer, seller, or |
| reseller. To locate a reseller near you, |
| call |
| directly from Compaq, visit the |
| Compaq web site at |
| http://www.compaq.com/products/ |
| projectors. |
| To replace the lamp, follow the |
| procedures in the “ Replacing the |
| Projector Lamp Module” section in |
| Chapter 5, “ Care and Maintenance.” |
|
|
Troubleshooting
