Rinse Agent Dispenser
Open the rinse agent dispenser by lifting the tab with your thumb as shown in Figure 17.
Add liquid rinse agent to the dispenser as shown in Figure 18 until the rinse agent reservoir is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full.
NOTE: The dishwasher indicates low rinse agent either by showing the symbol 
in the countdown display, or illuminating the refill rinse agent light as shown in Figure 19 (model dependent).
NOTE: After filling the rinse agent dispenser, the indicator light will go out in a few minutes after the dishwasher door is shut (select models).
Operating the Dishwasher
Always make sure your dishware is dishwasher safe. Refer to the Dishware Materials section of this manual for guidance.
Wash Cycles
Power Scrub Plus
Cleans items having
Regular
Thoroughly cleans large loads having loosely attached normal soiling.
Delicate/Economy
For delicate or heirloom dishwasher and silverware or other special items. Always make sure that the items are dishwasher safe. Refer to the Materials section of this manual for further information. Hand washing may be the best treatment of such items.
Quick Wash
For lightly soiled items with easy to remove food soils.
Rinse and Hold
Allows you to rinse the food soil off of a partial load and hold them in the dishwasher until there is a full load.
More information on dishwasher cycles is located in the Wash Cycle Information section of this manual.
Wash Cycle Options
Half Load
In the Power Scrub Plus, Regular and Auto Wash cycles you can reduce the energy and water consumption when washing small, lightly soiled loads that fill approximately half of the dishwasher’s capacity. To activate, select the Half Load button in addition to the Power Scrub Plus, Regular or Auto Wash cycle button.
Extra Dry Heat
With this option you can raise the temperature of the rinse water and increase the drying time which will result in improved drying.
NOTE: The unit must be powered OFF before activating To activate:
·Press and hold the left “Cancel / Drain” button (see Figure 20), then press and hold the
On/Off button.
·When the LED display shows a “00” or a “01” release both buttons.
·To enable the Additional Drying Heat, press the left “Cancel / Drain” button until the LED display shows a “01”.
·To disable the Additional Drying Heat, press the left “Cancel / Drain” button until the LED display shows a “00”.
Figure 19
Figure 20
12
