Compaq VX1 manual Installation, OpenVMS Version

Table 4-1 OpenVMS Version Supporting 3Dlabs OXYGEN VX1 PCI Graphics Controller

OpenVMS Version

Alpha Platform

7.3

7.2-1H1

7.2-1

7.1-2

Automatically loaded on the system when using this version for an upgrade or installation.

Copy the POLYCENTER Software Installation patch kits from net location http://www.support.compaq.com/patches/*

OR

Copy the patch kits by anonymous ftp at http://ftpl.support.compaq.com in VMS version specific subdirectories of /public/vms/axp/

Prior to 7.1-2

Not supported

*Caution: The required list of patch kits for a particular version of OpenVMS can vary over time. Check the Readme files associated with each of the kits to be sure that the patch kit is appropriate for your usage.

4.2Installation

This section covers installation of the 3Dlabs OXYGEN VX1 PCI graphics controller software driver on various versions of the OpenVMS operating system.

4.2.1OpenVMS Version 7.3

For OpenVMS Version 7.3 and higher, the 3Dlabs OXYGEN VX1 PCI graphics controller support software is loaded automatically following installation and becomes active when the operating system is booted. No other action needs to be taken by the system operator.

4.2.2OpenVMS Versions 7.1-2, 7.2-1, and 7.2-1H1

To install the 3Dlabs OXYGEN VX1 PCI graphics controller support software on OpenVMS Version 7.1-2, 7.2-1, or 7.2-1H1, you must copy the latest UPDATE and GRAPHICS POLYCENTER Software Installation utility patch kits from the World Wide Web location at http://www.support.compaq.com/patches/ or via anonymous ftp at ftp1.support.compaq.com. Then, use the POLYCENTER Software Installation utility (DCL PRODUCT INSTALL) to install the latest UPDATE kit and the

4-2 3Dlabs OXYGEN VX1 PCI Graphics Controller Installation Guide