Compaq VX1 manual Installation Procedure

2.3Installation Procedure

The following section describes how to install the 3Dlabs OXYGEN VX1 PCI graphics controller. To install the module, perform the following steps:

____________________________ Note _______________________________

Before installing the module, check your monitor specification for signal compatibility and supported features offered by the 3Dlabs OXYGEN VX1 PCI graphics controller.

_________________________________________________________________

___________________________Caution _____________________________

Static electricity can damage sensitive electronic components. When handling your graphics option, use an anti-static wriststrap that is connected to a grounded surface on your computer system.

_________________________________________________________________

1.Perform a normal power-down of your computer system and disconnect the monitor cable.

2.Disconnect all AC power cables from the wall outlet (or turn off the circuit breakers if applicable to your system) to remove power from the system.

3.Remove the cover from your computer (refer to your system documentation).

4.Put on an anti-static wriststrap.

___________________________Caution _____________________________

An anti-static wriststrap must be worn when handling any module to prevent damage to the module.

_________________________________________________________________

5.If your computer has an existing graphics module, remove the screw that secures it and then remove the module.

6.If your system had a previously installed graphics option, you can use that slot if it is a PCI slot, or you can select any empty PCI expansion slot on the primary PCI bus. Remove the slot cover if you are using a new slot. Refer to your system owner’s guide for information about graphics option slots.

2-2 3Dlabs OXYGEN VX1 PCI Graphics Controller Installation Guide