22 Chapter6 - Basic Configuration Guide
PPP ConfigurationThis sectionco vers thes ettings required forPP P(po int-to-point)
protocoloperation of the WAN interfaces.
Link Configuration
Requiredfor Dedicated/Leased Line Operation
Dedicatedli ne operationi s thes implest to set up.
• SetDedicated connection
• SetPP P connection
CV: Usethe Link Configuration: WAN1 Dialog Box.
TB: Use configureand set the Mode and ConnectMode keywords in
the LinkConfig WAN 0 (and/or WAN1) section.
Suggestedfor Dedicated/Leased Line Operation
Dedicatedli ne operationgenerally does notrequire additional parame-
tersfor operation.
Requiredfor Dial-On-Demand Operation
Incoming dial-on-demand operation re quires only slightly more infor-
mationthan dedicated line setup. Outgoing dial-on-demand requires
additional information (see the suggested settings below).
• Setdial-up connection
• SetPP P connection
• Set to allow dial-inand/o rdial-o ut
CV: Usethe Link Configuration: WANDialog Box.
TB: Use configure and set the Mode,ConnectMode,DialIn and/or
DialOut keywordsin the Link Config WAN 0 (and/or WAN1)
section.
Suggestedfor Dial-On-Demand Operation
Thismode of operation is only supported on the WAN 1 RS-232 inter-
face. Outgoing dial-on-demand requires some additional information.
• Create dial-out script
• Setdialing method
• Setdial-out script to be used
• Set inactivity time
CV: Usethe Link Configuration: WAN1 Dialog Box to set the dialing