Chapter6 - Basic Configuration Guide 23
TB: Use configureand set the Mode and ConnectMode keywords in
the LinkConfig WAN 1 section.
Suggestedfor Dedicated/Leased Line Operation
Dedicatedli ne operationgenerally does notrequire additional parame-
tersfor operation.
Requiredfor Dial-On-Demand Operation
Thismode of operation is only supported on the WAN 1 RS-232 inter-
face. Incoming dial-on-demand operation requires only slightly more
informationthan dedicated line setup. Outgoing dial-on-demand
requires additional information (see the suggested settings below).
• Setdial-up connection
• SetPP P connection
• Set to allow dial-inand/o rdial-o ut
CV: Usethe Link Configuration: WAN1.
TB: Use configure and set the Mode,ConnectMode,DialIn and/or
DialOut keywordsin the Link Config WAN 1 section.
Suggestedfor Dial-On-Demand Operation
Thismode of operation is only supported on the WAN 1 RS-232 inter-
face. Outgoing dial-on-demand requires some additional information.
• Create dial-out script
• Setdialing method
• Setdial-out script to be used
• Set inactivity time
CV: Usethe Link Configuration: WAN1 Dialog Box to set the dialing
methodand to select a chat script (once you have created one).
Usethe WAN Chat Scripts Dialog Box (under Global/WANChat
Scripts)to createy our chat script.
TB: Use configure and then set the Dialing,DialOutScript,and
DropInactkeywords in the Link Config WAN 1 section. Use
edit config and create a Chat section to contain your dialing
script.