ATTENTION:Read this so no one gets hurt
We design equipment with the user’s safety in mind. You can avoid the potential
hazards identified on this machine by following the procedures outlined below and
elsewhere in the User Guide.

WARNING: Improper installation, operation, or

servicing may result in equipment damage or

personal injury.

This equipment should be installed, adjusted, and serviced by qualified
technical personnel who are familiar with the construction, operation,
and potential hazards of this type of machine.
All wiring, disconnects, and fuses should be installed by qualified elec-
trical technicians in accordance with electrical codes in your region.
Always maintain a safe ground. Do not operate the equipment at power
levels other than what is specified on the machine serial tag and data
plate.

WARNING: Voltage hazard

This equipment is powered by three-phase alternating current,
as specified on the machine serial tag and data plate.
A properly sized conductive ground wire from the incoming power
supply must be connected to the chassis ground terminal inside the
electrical enclosure (control center).Improper grounding can result in
severe personal injury and erratic machine operation.
Always disconnect and lock out the incoming main power source before
opening the control center or performing non-standard operating proce-
dures, such as routine maintenance. Only qualified personnel should
perform troubleshooting procedures that require access to the control
center while power is on.
1-4 l Introduction