9
L36 LOUVRE INSTALLATION
FIGURE14
A
ACLIPS
FLANGE
HOOD
Attach the hood by pressing the top fl ange into the clips along the top of the louvre opening. Secure using a screw through the centre slot.
B
C
CENTRE
SLOT
B
C
HINGE
CLIP
SLOT
TAB
SLOT
UPPER LOUVRES
Insert the louvre tabs into the slots located at the top left and right corners of the unit.
LOWER LOUVRES
Insert the hinge clips into the slots located at the bottom left and right corners of the unit.
To remove the louvres, pull the back tabs of the clips forward, while pushing the louvre assem- bly back. Lift the clip.
OPTIONAL BLOWER INSTALLATION
INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be electrically connected and grounded in accord- ance with local codes. In the absence of local codes, use the
current ANSI/NFPA 70 NATIONAL ELECTRICAL CODE.
FIGURE 15
If the fireplace was not previously equipped with a blower: route a grounded
the bracket before installing the blower. Attach the black and white wires to the disc, then secure the bracket to the stud at the bottom left on the unit using the lock washer and wing nut. Ensure that the thermodisc touches the fi rebox wall.
Slide the vibration reducing pad (A) into the clip (C) and up against the threaded stud (B) at the other end. The blower must be able to be positioned entirely onto the pad.
Tilt the blower onto its side. Slide it past the controls and into the clip (C). Secure to the threaded stud using the lock washer and wing nut provided. Ensure that the blower does not touch the fi replace base or the fi rebox.
The three slots on the blower mounting bracket allow ease of adjustment when attaching the blow- er. For a quiet running blower, do not allow the assembly to sit on the fi rebox base.
FIGURE 16
If optional blower kit is to be installed, remove thermodisc from the bracket supplied in the kit and disgard the bracket. Install thermodisc in the bracket supplied with the fireplace. It is recommended to attach the wires to the disc and install
B
C
A
FIGURE 17 | FIGURE 18 |
