Cabletron Systems EMM-E6 manual B.3.2 Installing SIMMs

Appendix B: Upgrading the EMM-E6

B.3.2 Installing SIMMs

The EMM-E6 uses an angle-down slot (where the SIMM rotates down to a horizontal locked position). Installing a SIMM in any slot is a simple two-step process. After finding the proper SIMM slot location

(Figure B-3), refer to the procedures below.

Observe all antistatic precautions when handling sensitive

!electronic equipment.

C AUT IO N

1.Insert the SIMM between the connector teeth in the SIMM slot.

2.Pivot the SIMM down until it locks into the clips in the SIMM slot, and the SIMM holes fit over the SIMM slot posts. (See Figure B-4.)

	SIMM Slot
Connector	Clips
Teeth

	1
2	SIMM Slot
	Post
SIMM
SIMM Hole	Alignment Notch

1926n18

Figure B-4 Installing a Horizontal SIMM

B-4 EMM-E6 Installation Guide