Using the Reset Switch
4.3USING THE RESET SWITCH
The EMM-E6 incorporates a recessed reset switch, located above the LANVIEW LEDs (See Chapter 2, Controls and Indicators, for location). This reset switch initializes the EMM-E6 processor. This switch does not initialize Non-Volatile Random Access Memory (NVRAM), the non-volatile random access memory where the EMM-E6 stores network management parameters.
To use the reset switch, use a pen or pencil to press the switch in. When this is done, the EMM-E6 initializes itself.
The reset sequence for the EMM-E6 may last approximately one minute. The final time may change depending upon the configuration of the chassis in which the EMM-E6 is located. Only after the reset sequence is completed will internetworking operations resume.
EMM-E6 Installation Guide | 4-7 |
