Cabletron Systems EMM-E6 manual B.2 ADDING EPIMS

Appendix B: Upgrading the EMM-E6

B.2 ADDING EPIMS

This section contains procedures for adding or replacing an Ethernet Port Interface Module (EPIM) to upgrade or change the capabilities of your EMM-E6. After installing your new EPIM, refer to Chapter 3, Installation, for network connection instructions.

NOTE

The EMM-E6 EPIM slots are designed to provide redundancy. Only one EPIM will be active at any time. The inactive EPIM port will be held in standby, and will be immediately activated in the event of a filure ofthe primary EPIM port.

Observe all antistatic precautions when handling sensitive

!electronic equipment.

C AUT IO N

To install an EPIM, perform the following steps:

When removing an existing EPIM, make sure to pull the

!module straight out to avoid damage to the connector.

C AUT IO N

1.Remove the coverplate or the existing EPIM (whichever applies).

2.Slide your new EPIM into place, making sure the connectors on the rear of the module and inside the EMM-E6 attach properly. Refer to Figure B-2.

3.Secure the EPIM to the EMM-E6 by tightening the mounting screw.

Mounting

Screw

LNK

EPIM

1926n16

Figure B-2 Installing an EPIM

B-2 EMM-E6 Installation Guide