Cabletron Systems EMM-E6 manual Module Guide Channels

Chapter 3: Installation

4.Firmly press the module connections into the backplane. Do not try to force the module into place or use the knurled knobs to draw the module into the backplane.

1926n07

Module Guide Channels

Figure 3-3 Installing the EMM-E6

5.Secure the module to the MMAC chassis by tightening the knurled knobs. If you do not tighten the knurled knobs, vibration can cause the module to lose contact with the backplane and disrupt your network.

6.Reinstall the MMAC chassis safety bars.

7.Power-up the MMAC (if it is not already ON).

8.Observe the status of the LANVIEW LEDs (Figure 3-4) on the EMM-E6. When the CPU LED is amber, the module is in boot state. During this approximately one minute period the EMM-E6 cycles through a series of internal diagnostics.

3-8 EMM-E6 Installation Guide