Connecting to the Network
Position X (crossed over)
1. RX+ | 5. NC |
2. RX- | 6. TX- |
3. TX+ | 7. NC |
4. NC | 8. NC |
Position =
(not crossed over)
1. TX+ | 5. | NC |
|
2. TX- | 6. | RX- |
|
3. RX+ | 7. NC |
| |
4. NC | 8. NC | 1926n08 | |
Figure 3-5 EPIM-T Crossover Switch
1.Align the RJ45 connector with the socket of the RJ45 port. The connector will only insert and lock if the raised locking clip of the RJ45 connector is inserted into the correct location.
2.Press the RJ45 connector into the port until the click of the locking clip is felt. The pressure required to perform this should be minimal. If you encounter resistance or excessive friction, remove the connector and check the port for obstruction. Also, verify that the connector and the port are of the same type.
Once the locking clip snaps into place, the RJ45 connector will remain in the port.
3.Check that the LNK indicator LED is ON. If the indicator is not ON, the port does not have a valid link. Perform each of the following steps until you reach a resolution of the problem and achieve a link.
a.Check that the
b.Verify that the RJ45 connectors on the twisted pair segment have the proper pinouts.
|
