any equipment.
Disconnect the power cord when the appliance will be idled for a long period of time.
Do not attempt to service this unit yourself as removing any covers may cause exposure to dangerous voltage.
Always route the power cord so that it is not likely to be walked on or pinched by other appliances. Never use extension cords.
Do not overload outlets with more than one appliance. This can result in fire or electrical shock.
Your model is equipped with a grounded and polarized plug. Do not defeat the purpose of this plug by removing the ground post or using a non- polarized adapter without properly grounding the outlet.
Never connect any appliance to a power source while standing in water or with wet hands.
When a replacement part is required, always insist on factory authorized parts only.
MAINTENANCE
PERIODIC CLEANING PROCEDURE
It is best to clean your refrigerator or freezer when the product load is at its lowest level inside your cabinet. To clean the interior or exterior cabinet surfaces, the following procedure should be followed:
1.Disconnect your model from its power supply and remove all food product from inside.
2.Open all doors and allow the cabinet to reach room temperature. Remove all accessories (shelves, racks, pilasters, clips, etc.) from within the model, wash with a baking soda and warm water solution, and rinse thoroughly with clear water. Dry all of the accessories completely with a soft clean cloth.
3.Once the cabinet has reached room temperature, wash the entire cabinet inside and out with a baking soda and warm water solution. For slightly more difficult cleanups, ammonia or vinegar in warm water can be used. Rinse thoroughly with clear water and dry with a soft clean cloth. Failure to dry all surfaces completely may cause water stains or streaking on the aluminum or stainless steel finish.
4.Return all accessories to their respective positions and return electric supply power to the model.
PRECAUTIONS
1.Never use harsh detergents, cleaners, scouring powders, or chemicals when cleaning your model.
2.Strong bleaches tend to corrode many materials and should never come in
-20 -
