Cooper Bussmann BU-905U-L Configuring Your Units, Signals Sent Over Radio, Other Signals

Cooper Bussmann BU-905U-L Wireless I/O Installation Manual

Configuring Your Units

You can configure your network using:

•Default factory configuration – that lets you easily setup your network as a simple send/receive; or

•User-defined customized configuration – that lets you set specific information about your network and allows communication with other Cooper Bussmann BU-905U-L Series devices.

For more information on setting a user-defined customized configuration, see the User Manual.

For more information on setting the factory default configuration, refer to the Quick Start Guide included with your module.

The following table details the factory default configuration:

Signals Sent Over Radio

BU-905U-L-T (Transmitter)

Digital Input 1

Digital Input 2

Analog Setpoint

Analog input (4-20mA)

Other Signals

BU-905U-L-T (Transmitter) Thermocouple Input (Not used) Setpoint Output (Local indication) System OK (On if system OK)

Sends BU-905U-L-R (Receiver)

￿Digital Output 1

￿Digital Output 2

￿Digital Output 3

￿Analog output

BU-905U-L-R (Receiver)

Communication Failure (Comes on if no messages from BU-905U-LT) Communication Failure (Comes on if no messages from BU-905U-LT) System OK (On if system OK)

24 www.cooperbussmann.com/BussmannWirelessResources 3A1580Rev1.6