Cooper Bussmann
The front panel contains the following components:
SMA Antenna Connector at Top of Unit
Indicator LEDs
RS232 Configuration Port
Rotary Switch for Setpoint Settings
The triangle on the rotary switch indicates the current position, for example:
NOTE: To avoid damaging the rotary switch, use a screwdriver to change the position.
The rotary switch controls the setpoint levels on the Analog and Thermocouple inputs.
The LEDs on the front panel indicate the unit status:
LED Status | Indicates |
| ||
None | No power supply. | |||
OK LED Green | Current status of the unit OK. | |||
OK LED Red | Fault condition detected in unit. | |||
TX Led Flashes | Transmitting Message. | |||
PG LED on | Configuration Cable Connected. | |||
Input LED ON | Input LEDS (i.e., D1, D2, SP, AZ.) light when the corresponding input is active. | |||
| D1 |
|
| Digital Input 1 is active (Low). |
|
| |||
| D2 |
|
| Digital Input 2 is active. |
| SP |
|
| Analog Setpoint is active. |
| AZ |
|
| Analog Input is zero mA |
All LEDs medium flash | Medium speed flash (1.6Hz) indicates the module is halfway through the configuration process. | |||
| Medium flash also happens when you set the rotary switch to position 0 when powering on the unit. | |||
6 | www.cooperbussmann.com/BussmannWirelessResources | 3A1580Rev1.6 |
