Cooper Lighting Envoy manual Mounting Configurations, Standard J-Box Mount, Recessed, Surface

7

8

MOUNTING CONFIGURATIONS

13 1/2"

[343mm]

Approx.

	3 7/16" [88mm]
14 7/8"
[378mm]	16 5/8"
Approx.

[423mm]

STANDARD J-BOX MOUNT

[Recessed]

The J-Box is recessed/cast into ceiling. Envoy is attached using the quick mount release bracket system.

8 3/8"

STANDARD J-BOX MOUNT	PENDANT BOX/BIRD GUARD [PBG]
[Surface]	The pendant box accessory also acts as a
The J-Box is surface mounted to ceiling	bird guard and may be used with a free
where J-Box and conduit are visible. Envoy	swinging or rigid pendant system,
is attached using the quick mount release	allowing the fixture to level and hang
bracket system.	straight. Envoy is attached using the same
	quick mount release bracket similar to
	J-Box installation.

[213mm] Adustable to 13 1/4"

13 1/8"

[334mm]

7/8"

[22mm]

131/8"

[334mm]

20 7/16" [519mm]

4 1/16"

[104mm]

1315/16"

[354mm]

TRUNNION-MOUNT [TM]

The trunnion mount bracket allows direct attachment to ceiling using anchors and provides a 1/2" threaded connection box for wiring connections outside the fixture. Trunnion mount is adjustable from 8 3/8" to 13 1/4" depth off mounting surface to top of fixture. Water-tight power cord option is available.

THROUGH BRANCH WIRING

DIRECT SURFACE MOUNT WITH CONDUIT

Cast in “knock outs” are provided on the back surface of the cast housing to allow mounting directly to concrete surface using anchors. Power is routed through Conduit Taps [CT] option, that are located 90° offset from latches.

WALL MOUNT [WM]

The wall mount arm allows you to match path or perimeter lighting within or outside the garage. Envoy is attached using the same quick mount release bracket similar to J-Box installation. Power is routed in wall and through access hole within arm to fixture.

Rated for use with 4IN/4OUT #12GA wires. Through branch wiring requires Conduit Tap [CT] option and provides [2] 3/4" NPSM threaded hubs for wire access into side of fixture.