TM
INSTALLATION INSTRUCTIONS
IMPORTANT: READ CAREFULLY BEFORE INSTALLING FIXTURE.
Ascent/Strut Fixtures
Sheet 4 of 5
4/26/04
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing.
WARNING: Risk of Personal Injury. Fixture may become damaged and/or unstable if not installed properly. Tighten all fixture components to their recommended torque values.
9.To reinstall POWER TRAY, hang POWER TRAY from POWER TRAY HINGE, swing POWER TRAY up till POWER TRAY LATCH snaps closed. Reconnect PRIMARY QUICK DISCONNECT. Install lamp. Reinstall DOOR at
Fig. 9
NOTE: Prior to installing the lamp, check to make sure lamp is of proper type and wattage. Observe lamp manufacturer’s recommendations and restrictions regarding lamp operation.
NOTE: Reflector are marked to insure reflector is installed in proper orientation regarding “Street Side”. If other orientation is desired, reflector may be rotated 90° in either direction.
REFLECTOR Rotation/Removal:
10.Open DOOR by depressing LATCH BUTTONS into door. (Reference Fig. 1)
11.To lower REFLECTOR, press the two REFLECTOR TABS outward and swing the REFLECTOR down. (Fig. 11a & 11b). The REFLECTOR may now be lifted off of its hinges for rotation or removal.
Fig. 11a
REFLECTOR
TABS
REFLECTOR
Fig. 11b
REFLECTOR
TABS
REFLECTOR
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please contact your nearest representative.
Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269