Cornelius 750 Pre-Mix manual Introduction, Unpacking The Kit, Required Supplies And Equipment

IMI CORNELIUS INC.

One Cornelius Place

Anoka. MN 55303-6234

Telephone (800) 238–3600

Facsimile (612) 422–3246

COPPER EVAPORATOR COIL KIT (P/N 185216000)

ON

UNIVERSAL 750 PRE-MIX DISPENSER

IMPORTANT: Only qualified Personnel should install this Kit.

INTRODUCTION

The purpose of this kit is to replace the original expanded aluminum evaporator, which also doubles as the wa- ter bath tank, with a new copper tube style evaporator. The old aluminum evaporator remains in place as the water bath tank only.

A new anode and refrigeration system dual inlet strainer/dryer are also included with the kit and must be instal- led.

Retain these instructions as part of your equipment manual.

UNPACKING THE KIT

Unpack and inspect the kit. Make sure Loose-Shipped Parts are present and in good condition (see Figure 1).

Table 1. Loose-Shipped Parts

Item
No.	Part No.	Name	Qty.
1	319238088	Suction Line Ass’y	1
2	186843000	Anode	1
3	187969000	Sheet Metal Screw, Phil Pan Hd, Type ‘‘A’’ Alum; No. 10 by 1/2-in.	1
4	185215000	Copper Evaporator Coil	1
5	319225000	Coil Spacer	4
6	320389000	Thread Rolling Screw, Phil Pan Hd, No. 6-32 by 1/4-in.	4
7	960050	Rubatex Insulation, 6-ft. long	1
8	2601	Strainer Dryer, Dual Inlet	1
9	189159001	Instructions	1

REQUIRED SUPPLIES AND EQUIPMENT

Supplies required are as follows:

Brazing alloy ‘‘Phos-Copper’’, ‘‘Silfos’’ or equivalent is required for copper-to-copper connections. These alloys contain about 15% silver.

Brazing alloy. ‘‘Easy-flow’’ or equivalent is required for copper-to-steel connections. This alloy contains about 50% silver.

EIMI Cornelius Inc; 1984-91

Revised: December 10, 1991

November 30, 1984

189159001