Starting & Operating
Before Starting
Check the oil and gas levels.
Check the tires for proper inflation.
Check the latch on the dump
Set the parking brake.
Shift the transmission to neutral.
Electric-Starting
1.When starting a cold engine, push the primer bulb (Figure 7) firmly at least three times, allowing the bulb to return completely to its original position between pushes.
Note: Do not use the primer when restarting a warm engine.
2.Turn the key (Figure 8) past the "START" position to engage the starter. As soon as the engine starts, release the key. If the engine doesn't start repeat priming and try again.
Note: Holding the throttle control lever at half throttle may help with starting.
If the engine won't start with the key the battery may need to be charged. Please see page 10 for information on battery care and maintenance.
Your engine is also equipped with a manual recoil starter. Please see the instructions below.
Manual Recoil-Starting
Can be used for both Electric- and Manual-
Starting models.
1. When starting a cold engine, push the
primer bulb (Figure 7) firmly at least three times, allowing the bulb to return completely to its original position between pushes.
Note: Do not use the primer when restarting a warm engine.
2. Turn the key (Figure 8) to the "START" position.
4 | DR® POWERWAGON™ Safety & Operating Instructions |