Removing the Front Wheels
Tools & Supplies Needed:
•(2) 7/16" wrenches
•block to raise machine off ground
!WARNING: Always disconnect the
spark plug wire before servicing your machine.
1. Block the machine so the wheel is an inch or two off the ground.
2. Using (2) 7/16" wrenches, loosen the bolt (Figure 32) and slide the wheel off the axle.
Adjusting the Shift Lever
Figure 32
If you are unable to shift into reverse or 2nd gear, the shift lever and tie rod need to be adjusted.
Tools needed:
•(2) 1/2"
!WARNING: Always disconnect the
spark plug wire before servicing your machine.
1. | Remove the dump body. |
|
2. | Move the shift lever into the reverse |
|
| position. |
|
3. | Loosen and remove the tie rod nut and | Figure 33 |
| bolt from the transmission arm (Figure |
33). Unhook the tie rod from the transmission arm.
4.Fully extend the transmission arm toward the rear of the DR® POWERWAGON™, this will put it in reverse gear.
5.Loosen the lock nut on the eye bolt (Figure 34), and turn the eye bolt one turn at a time to take up slack in the tie rod. Place the tie rod back on the transmission arm, insert the nut and bolt and retighten. This should enable you to engage the full range of gears.
Figure 34
16 | DR® POWERWAGON™ Safety & Operating Instructions |