Adjusting the Brake
If the DR® POWERWAGON™ rolls on slopes when the parking brake is set, or you can't get the parking brake to set, the brake needs to be adjusted.
Tool Needed:
• 1/2" wrench
!WARNING: Always disconnect the
spark plug wire before servicing your machine.
1. | With the machine on a level surface, set |
|
| the parking brake. |
|
2. | Put the transmission in Neutral. |
|
3. | Test the brake: Try to roll the machine. It |
|
| should not move forward or back with the |
|
| parking brake set. |
|
4. | If the machine does move, turn the nut on | Figure 27 |
| the transaxle (Figures 27 & 28) 1/4 turn |
clockwise to tighten the brake. Repeat Steps
Note: Turn the nut only 1/4 turn at a time, then test the brake to see if further adjustment is needed.
If you can't get the parking brake to release, turn the nut on the transaxle (Figures 27 &
28)1/4 turn counterclockwise to loosen the brake. Repeat Steps
Figure 28
Brake Cable Adjustment
The brake cable is
Figure 29
14 | DR® POWERWAGON™ Safety & Operating Instructions |