ASSEMBLY AND ADJUSTMENTS
Estimated Assembly Time: 5 – 10 minutes
!WARNING
To avoid injury, do not connect this miter saw to the power source until it is completely assembled and adjusted and you have read and understood this Operator’s Manual.
INSTALLING THE MITER HANDLE (FIG. A)
1.Thread the miter handle (1) into the hole located at the front of the miter table.
Fig. A
1
UNLOCKING THE SLIDE CARRIAGE (FIG. B)
After removing the saw from the carton, loosen the slide carriage lock knob
(1). When transporting or storing the miter saw, the slide carriage should always be locked in position. The slide carriage lock knob (1) is located on the right side of the slide carriage.
Fig. B
SAW BLADE WRENCH (FIG. C)
1.For convenient storage and prevention of loss, there is a slot (1) in the rear of the carrying handle
(2) for storing the blade wrench (3) when not in use.
Fig. C | 2 | 1 | 3 |
|
RELEASING CUTTING HEAD (FIG. D) Unlocking
!WARNING
To avoid injury and damage to the saw, transport and store the miter saw with the cutting head locked in the down position. Never use the stop latch to hold the cutting head in a down position for cutting operations.
1.Push down slightly on the switch handle (1).
2.Pull out the stop latch knob (2).
3.Allow the cutting head to rise to the up position.
Fig. D
1
2
1
18 
